Utax P-6035i MFP User Manual download pdf (Page 402)

11-21

Appendix > Paper

Hagaki

Before loading Hagaki into the multi purpose tray, fan them and align the edges. If the Hagaki paper is curled, straighten

it before loading. Printing onto curled Hagaki may cause jams.

Use unfolded Oufuku hagaki (available at post offices). Some Hagaki may still have rough edges developed by a paper

cutter on the back side. Remove any such rough edges by placing the Hagaki on a flat surface and rubbing the edges

gently a few times with a ruler.

Envelopes

Envelopes should be fed from the MP tray with the print-side up or the optional paper feeder (PF-320) with the print-side

down.

For P-4030i MFP/P-4035i MFP, set envelope mode. Refer to Switching to Envelop Mode (

P-4030i MFP/P-4035i MFP)

on page 3-20.

Due to the structure of envelopes, printing evenly over the entire surface may not be possible in some cases. Thin

envelopes in particular may be wrinkled by the machine in some cases as they pass through. Before purchasing

envelopes in volume, try testing a sample to ensure the print quality.

Storing envelopes for a long period may cause them to become wrinkled. Thus, keep the package sealed until you are

ready to use them.

Keep the following points in mind.

• Do not use envelopes with exposed adhesive. In addition, do not use the type of envelope in which the adhesive is

exposed after the top layer is peeled off. Serious damage may be caused if the paper covering the adhesive comes

off in the machine.

• Do not use envelopes with certain special features. For example, do not use envelopes with a grommet for winding a

string to close the flap or envelopes with an open or film-covered window.

• If paper jams occur, load fewer envelopes at once.

• To prevent paper jams when printing onto multiple envelopes, do not allow more than ten envelopes to remain in the

Inner tray at once.

Thick Paper

Before loading thick paper in the multi purpose tray, fan it and align the edges. Some thick paper may still have rough

edges developed by a paper cutter on the back side. Remove any such rough edges just as with Hagaki by placing the

paper on a flat surface and rubbing the edges gently a few times with a ruler. Printing onto paper with rough edges may

cause jams.

NOTE

Do not load paper above the load limits located on the paper width guide of the optional paper feeder.

NOTE

If the paper is not supplied correctly even after it is smoothed, load the paper in the multi purpose tray with the leading

edge raised a few millimeters.

Burrs

1 2 ... 397 398 399 400 401 402 403 404 405 406 407 ... 420 421

No comments

Utax P-6035i MFP User Manual Page 402